Some things are obvious but often do not cause and can not light up the plant when you need it and in extreme cases can cause damage to your computer.
Most of the plants of light FGW the maintenance interval is every 500 hours for oil and filter change but within this period is important for the operator to make regular reviews of the team.
Before anything make sure you review or the room or area where it was installed plant light FGW is clean!
If the room is not clean can hardly see or detect fluid leaks in the equipment. Check for Cartons, bags or other objects can be sucked by the team and to obstruct the flow of air when the team is working on and make you hot ..
On the computer it is necessary to review the following points.
Review the level of fuel in the tank and fuel:
This seems obvious but it is critical that they see the fuel level in the tank. It is very common that as the plant is not used daily light take someone "borrowed" the fuel for something else and do not replace or fuel without leaving much less than they charged. There is nothing worse than find out when a power outage. FGW light plants come with a fuel level indicator on the tank base where you can check the level.
When loading of fuel and the revisions during a review that does not have water fuel. Water is a mortal enemy of the injection equipment. Within a few hours of use can damage components such as injection pump or nozzles that are very costly.
Reviewing the oil level and quality:
Although the oil is changed every 500 hours it is important that the oil level at the correct level. If the oil level is too low can damage the engine due to lack of lubrication. If the level is too high may cause leakage of the seals of the engine.
The manual indicates the exact type of oil to be used at different temperatures. The oil quality is critical because it takes a change intervals and oil filter based on that quality. If the lower quality leads to degradation and not have to lubricate the engine. You must use common sense in applying this plant light.
Assuming oil change every 500 hours it is in normal working conditions. If there is a lot of dust or contamination should be taken into account and reduce service intervals.
Review the coolant and the coolant level:
You can check the coolant level by removing the radiator cap. If the radiator tubes are very low level and this must be filled. Reviewing the radiator cap to see if in good condition and properly sealed. The rate of cooling is critical as this may create corrosion of the radiator and other components such as water pump is not used right. When you check the level if the door is corrosion is a clear indication that the coolant is not correct.
Review the level of electrolyte in the battery and ensure that this position.
The biggest reason for not starting the plants of light per battery is dead. This failure is more common and many times is that the team has long been lost and the battery stopped charging. The control panel Power Wizard 1.0 FGW indicates battery level and low level alarm batteries. However it is important that the battery electrolyte is sufficient to maintain the load. Take the opportunity to review the battery terminals are not corroded.
It is always advisable to use a battery charger to maintain the level of the battery when turned off. If you have installed make sure the charger is connected to and charge the battery.
0 komentar:
Posting Komentar